Closing The Door; Installation - Zanussi ZFT11114WA Benutzerhandbuch

Problem
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.

Closing the door

1. Clean the door gaskets.

Installation

WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
20
Possible cause
The door is not closed correctly.
The food products' temperature
is too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in
the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
Make sure that there is cold air
circulation in the appliance.
"Installation".
gaskets. Contact the Authorised Service
Centre.
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Authorised Service
Centre.
Solution
www.zanussi.com