Ec Declaration Of Conformity; General Maintenance - REXON SM 3051AL Bedienungsanleitung

Changing the Batteries (Fig. 27)
Unplug your saw.
Failure to unplug your saw could result in accidental starting
causing possible serious personal injury.
1. Remove the laser guide from the saw.
2. Loosen and remove the two screws, then remove the
laser guide cover.
3. Remove the three batteries as arrow on Fig. 27 and
replace new batteries.
4. Replace the laser guide cover and two screws and
tighten.
NOTE: Replace the batteries with batteries that have a rating
of 1.5 volts (Number LR44).
When replacing the batteries, the battery cover should be
thoroughly cleaned. Use a soft paintbrush or similar device, to
remove all sawdust and debris.
Changing the Belt (Fig. 28, 29)
Unplug your saw.
1. Loosen the bolts (1) and remove the belt cover.
2. Turn the screw (2) counter-clockwise with an Allen wrench
to move the motor to forward.
3. Remove and replace the belt.
4. Turn the screw (2) clockwise with an Allen wrench to
move the motor to rearward. Do not over tighten.
5. Replace the belt cover and tighten the bolts.
Maintenance
WARNING: For your own safety, turn the switch off and
remove the plug from the power source outlet before
maintaining or lubricating your mitre saw.

General Maintenance

Occasionally use a cloth to wipe off chips and dust from the
machine. And oil the rotary parts once a month to extend the
tool life. Do not oil the motor.
Brush Inspection
Check the motor brushes after the first 50 hours of use for
a new machine or after a new set of brushes have been
installed. After the first check, examine them every 10 hours
of use.
When the carbon is worn to 6 mm in length or if the spring or
shunt wire is burned or damaged, replace both brushes. If the
brushes are found serviceable after removing, reinstall them.
EC-Declaration of
Conformity
Rexon Industrial Corp., Ltd. declares this Mitre Saw, Model
SM3051AL, is in conformity with the Low Voltage Directive
2006/95/EC; the Machinery Directive 2006/42/EC; the EMC
Directive 2004/108/EC.
Steve Pang, Marketing Manager
Date: 1 March, 2010
Rexon Industrial Corp., Ltd.
261 Jen Hwa Road
Tali, Taichung 412
Taiwan, R.O.C.
7