Ground Zero COMPETITION series Anschluss- Und Bedienungsanleitung Seite 12

Controls and features – GZCA 1.5SPL-M1/M2
1 RCA signal input
2 RCA signal output
3 Input sensitivity (LEVEL)
4 LP crossover switch
5 Low pass filter
6 High pass filter
7 Bass boost level
8 Bass boost frequency
Power status, clipping and
9
protection LED
* to avoid any kind of malfunction, it is strongly recommended to use high quality RCA wires!
1 wer terminal
Po
Speaker wire
2
terminal
To connect the RCA signal wire* from the audio source / head unit
To connect another amplifier (using an RCA cable)
To adjust the input sensitivity
To select the operation mode of the LP crossover
To adjust the low pass filter´s crossover point (80 Hz - 25 kHz)
To adjust the high pass filter´s crossover point (5 Hz - 80 Hz)
To adjust the bass boost level (0 to12 dB)
To adjust the bass boost´s center frequency (35 – 70 Hz)
Indicating the power and clipping status and activated protection mode
Connections – GZCA 1.5SPL-M1/M2
BAT To be connected to the positive terminal of the battery (+12 V)
REM To be connected to the remote output of the head unit
GND To be connected to the ground of the vehicle
To be connected to one or more speakers
(pay attention to the minimum load mentioned for your amplifier model)
GZCA 1.5SPL-M1
GZCA 1.5SPL-M2
Minimum load at terminal 1 ohm
Minimum load at terminal 2 ohm
4