Connect The Cables - Axis Communications T98A-VE Series Installationsanleitung

AXIS T98A-VE Series Installation Guide

Connect the Cables

• The electrical connections and conduit installations shall be made by a certified electrician
and in compliance with local regulations.
• The power supply shall always be connected to the mains supply at the end of the installa-
tion and not before.
• Cable gaskets shall be attached to all open cable holes in the cabinet base to maintain the
product's IP rating. If the holes are not sealed, water may seep into the cabinet and cause
damage to the devices inside.
• Cables routed through M20 gaskets shall have a diameter of 3.5 mm – 12.5 mm (0.14" –
0.49").
• Cables routed through M25 gaskets shall have a diameter of 9.1 mm– 12.5 mm (0.36" –
0.49").
• Signal and power cables shall always be separated within the cabinet.
To prepare a cable with a gasket, gently force the cable through the gasket provided and attach the
appropriate connector. It may be necessary to pierce a hole in the gasket with a screwdriver.
• Do not force the connector into the gasket.
• Do not pierce the gasket with a knife or other sharp object.
1. Route the cables required for the installation through conduits (not included), cable gaskets
and cable holes.
2. Attach the cable gaskets to the cable holes.
3. Connect the cables to and between the devices, except the power supply,
according to the manufacturers' instructions. Use the supplied cable clamps to
keep the cables organized. If installing an Axis network camera on the door,
refer to Install an Axis Network Camera (sold separately), on page 15.
4. If required, narrow the supplied electrical safety cover by cutting along the perforated line.
5. Open slots in the electrical safety cover as required by breaking the tabs.
6. Connect the power supply to the mains supply.
Page 13