Philips AZ 1120 Handbuch Seite 6

RADIO
Radio reception
1. To select the desired waverange, set the source selector to
FM/MW.
2. Tune to a radio station using the tuning knob.
– For FM, pull out the telescopic aerial. Incline and turn the
aerial. Reduce its length if the signal is too strong (very close to
a transmitter).
– For MW, the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning the
whole set.
3. Adjust the sound using the VOLUME and DBB controls.
4. To switch off the radio, adjust the source selector to the OFF/
TAPE position (with the cassette keys released).
CD PLAYER
Display indication for CD functions:
– Total track number: in stop mode
– Current track number: during CD play
– Current track number flashes when on PAUSE
– SHUFFLE/ REPEAT: modes: when the respective mode is
– PROGRAM: when active: P also appears briefly when you
store a track
– no: no disc/ error in CD operation or with the CD (see
Troubleshooting)
– F: programme memory full
Playing a CD
1. Set the source selector to CD.
2. To open the CD door, press OPEN on the CD door.
3. Insert a CD with the printed side facing up and press the CD
door gently close.
– The CD player scans the contents of the CD and the total
number of tracks is shown.
4. Press PLAY•PAUSE 2; on the set/ remote control to start
playback.
5. Adjust the sound using theVOLUME and DBB controls.
6. To interrupt playback press PLAY•PAUSE 2;. To resume,
press PLAY•PAUSE 2; again.
7. To stop CD play, press STOP 9 on the set/ remote control.
8. To switch off the set, adjust the source selector to the OFF/
TAPE position (with the cassette keys released).
Note: CD playback will also stop when:
– you press the CD door open;
– the source selector is in OFF/ TAPE or FM/ MW position;
– the CD has reached the end.
6
activated
CD PLAYER
CD
PROGRAM
CD