SSS Siedle AIVSE 670-0 Produktinformation Seite 3

English
Application
Access analogue video standard
interface in surface-mount housing
for connection to the integrated
camera at the ATLC 670-...
Following a door call, the picture
from the analogue camera automati-
cally appears on the Access indoor
call station. Manual selection of the
door is also possible. The camera
cannot be controlled.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
Mounting
In order to prevent damage to the
fitted electronic circuit, take great
care when pushing through the
rubber membrane through which
the installation cable is guided.
Installation
Note the supply voltage of the
camera, if applicable switch over the
sliding switch in the AIVS 670-...
1 Sliding switch in the AIVS 670-...
a 12 V DC
b 24 V DC
The circuit diagram required is pro-
vided with the Siedle Steel/Classic
product information.
Terminal assignment
V1 video signal
V2 (two-wire FBAS)
V3 power supply to the
V4 AIVS 670-...
V5 control input for the
V6 video signal and switching
output S 6
S5 * power supply 12/24 V DC
max. 200 mA, permanent
S6 * power supply 12/24 V DC
max. 200 mA, control
signal dependent
S7 common reference point
for S5, S6
L/S coaxial connection
L = lead, S = shield
* The total current from S5 - S7 and
S6 - S7 is limited to 200 mA. The
output voltage always corresponds
to the set switch position.
3