Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DO NOT RIDE ON DIRT, GRAVEL, GRASS, SLICK OR WET SURFACES.
•
THE SCOOTER IS MADE ONLY FOR DRY AND EVEN SURFACES.
NEVER RIDE OVER THE CURB OR SPEED RESTRAINTS WITH THIS SCOOTER; IT IS
•
NOT CONTSTRUCTED FOR SUCH USAGE. THE MERCHANT, IMPORTER OR
MANUFACTURER IS NOT LIABLE FOR INJURIES OR DAMAGES AS A RESULT OF
SUCH IMPROPER USAGE.
THE BREAKS ARE FOR SPEED CONTROL AND STOPPING. ONLY ONE PERSON AT A
•
TIME MAY RIDE THE SCOOTER, A LOSS OF CONTROL WOULD RESULT SHOULD
MORE THAN ONE PERSON RIDE THIS VEHICLE.
KEEP HANDS, FEET AND SHOE STRINGS AWAY FROM MOVING PARTS.
•
NEVER LEAVE CHILDREN ALONE WITH THIS PRODUCT: HAZARDOUS SITUATIONS
•
COULD RESULT.
GET TO KNOW THE SCOOTER AND CHECK ALL FASTENERS BEFORE ACTUALLY
•
USING THE SCOOTER.
NEVER STORE THE BATTERIES BY HIGH TEMPERATURES AS AN EXPLOSION COULD
•
RESULT.
THE LOADING DEVICE MAY NEVER BE SET OUT TO MOISTURE AND SHOULD NOT
•
BE USED AGAIN AFTER BEING DAMAGED. PLEASE CHECK THE CABLE; PLUG AND
MANTELING REGULARLY FOR DAMAGE. THE LOADING DEVICE MAY ONLY BE USED
AGAIN IF ANY DAMAGE HAS BEEN REPAIRED PROFESSIONALLY.
NEVER USE THE SCOOTER IF YOU ARE COMPROMISED IN ANY WAY.
•
INSTALLATION
Take the scooter out of the packaging
1.
Handlebar
Pull the handlebar out. Unlock the fastener to set the handlebars. Hold it firmly with both
hands. Press the spring mechanism. Push it into the t-shaped post. Take care that the
spring is inside the t-shaped post. Reverse this order to fold it back together.
2.
Loading device
The loading device for this product is a specially developed intelligent loader. The loading
itself does not have to be done by a professional. All that is required is a 110-230V AC/DC
connection. The loader avoids an overloading of the battery and keeps it in the best
condition. To load press the pin-plug into the socket on the vehicle and the power-plug
into a corresponding power socket. The loading time is 6 hours until fully loaded and the
operation of the vehicle is blocked during this time so that the scooter cannot be started.
3.
Drive Control
The drive control is the center of the drive vehicles system and incorporates a low current
safety, a current-foldback-circuit and a brake to disrupt the current.
4.
Battery
A lead-acid dry cell battery is used for this vehicle, which is conceived exclusively for the
use in electric vehicles; this has following advantages: no repairs are necessary and high
durability.
7
© Chal-Tec GmbH, Berlin. Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung der Chal-Tec GmbH.
Werbung
Inhaltsverzeichnis
