Personal Protective Equipment - EL BJORN TF 30HV Bedienungsanleitung

SAFETY
Read the instruction manual carefully and ensure you
understand the content before using the TF 30HV.
Safety during assembly
• The machine must be installed by a qualified professional.
• The machine may not be connected to an electrical
power supply during assembly and installation.
• Do not position the machine close to showers, baths,
pools etc.
• The machine must be installed on a level surface, and
must always remain vertical.
Safety during use
• Keep your work area tidy. Untidy workplaces and machines
increase the risk of accidents.
• Connect the electrical cable to a wall outlet protected by
a residual current trip and then start the machine with the
power switch.
• Take care not to damage the electrical cable. Do not jerk
the electrical cable out of the supply socket. Do not
expose it to heat, oil or sharp edges.
• Use of extension cables. Only use approved extension
cables that are marked for outdoor use.
INTRODUCTION
DESCRIPTION
The TF 30HV primarily consists of a powder coated steel chassis, wheels and an air distributor. The chassis contains a water
heater matrix, a fan and a replaceable filter. The TF 30HV draws in air through the air inlet on the side of the machine.
The air passes through a filter and is conducted through the fan and then through the heater matrix, which heats the air.
The air is forced out through the air distributor.
For optimal drying and heating results, position the machine as centrally as possible in the room.
The machine has two fan speeds. The higher speed is for normal operation. The lower speed is for increasing the outlet air
temperature when the machine is started in cold rooms.
It is very important that the machine runs continuously in order to achieve optimal drying and heating results.
NOTE!
All persons who use or repair the TF 30HV should first carefully read the section about safety. The user manual contains
instructions on use of the product, and on the various maintenance operations that can be performed by the operator.
More detailed service or troubleshooting may only be performed by the manufacturer's service staff. The user instructions describe
all the necessary safety features. The user should read the instructions carefully before connecting the TF 30HV to the power
supply. In other words, the first thing the user should do after delivery is to read the user instructions.
Symbols and warning signs that appear in this user manual and on the TF 30HV are shown on the following page. If any of the
warning signs on the TF 30HV are damaged or worn, new signs must be ordered and attached as soon as possible to ensure
maximum safety during use of the TF 1530HV. The machine may only be used for the purposes described in this instruction.
The manufacturer reserves the right to make changes.
APPLICATION AREA
The machine is intended for drying and heating buildings where there is a need for temporary heating, drying or air circulation.
The machine must be connected to an electrical supply protected by a residual current trip.
• Emergency measures. Disconnect the power by turning
off the power switch or pulling out the electrical cable.
• The product is not intended for use by persons
(including children) with reduced physical or mental
capacity, impaired judgement or lack of experience and
knowledge, unless they have been shown or instructed how
to use the product by a person who is responsible for their
safety.
• If children are allowed near the product, they must be
instructed not to play with or around the product.
Safety during service/maintenance
• Never open the inspection hatch during operation.
Always disconnect the power before opening the hatch.
• All repair of electrical parts must be performed by
authorised electrical staff.

PERSONAL PROTECTIVE EQUIPMENT

Use a respirator and gloves when replacing the air filter, as
a lot of dust may be generated.
MINIMUM EXPERTISE REQUIRED
The machine may only be repaired or serviced by an electrician
or other suitably qualified staff.
14
GB