Electrical Connection - Silca M-BOX Gebrauchsanleitung

M-BOX
English

ELECTRICAL CONNECTION

When the M-BOX module has been installed under the RW4 Plus, FastCopy Plus, Ezclone Plus, RW4 with
P-BOX or FastCopy with P-BOX or Ezclone with Plus-BOX machines make the electrical connec on:
Connecting to RW4 Plus or FastCopy Plus or Ezclone Plus. (Fig.6)
- Connect the power supply cable (M) provided with the M-BOX module to the connectors (E).
- Connect the RS-232 serial communica on cable (N) provided with the M-BOX module to the connectors (G)
- Fit the machine power supply cable (S) into the connector (D).
- To connect the M-BOX module to a PC fi t the USB cable provided (L) into the M-BOX port (C).
- To connect to the LAN network fi t an Ethernet cable (not provided) into the connector (I).
Connecting to RW4 with P-BOX or FastCopy with P-BOX or Ezclone with Plus-BOX (Fig.7)
- Connect the power supply cable (M) provided with the M-BOX module to the connectors (E).
- Connect the power supply cable (M1) provided with the P-BOX module to the connectors (E1).
- Connect the RS-232 serial communica on cable (N) provided with the M-BOX module to the connectors (G).
- Connect the RS-232 serial communica on cable (N1) provided with the M-BOX module to the connectors
(H).
- Fit the machine power supply cable (S) into the connector (D).
- To connect the M-BOX module to a PC fi t the USB cable provided (L) to the M-BOX port (C).
- To connect to the LAN network fi t an Ethernet cable (not provided) into the connector (I).
CONNECTING THE COM CODE MODULE (OPTIONAL)
Connecting to a RW4 Plus or FastCopy Plus or Ezclone Plus ( Fig.8)
- Connect the connectors (A) to the communica on cable (D) provided with the COM-CODE module.
- Connect the connectors (B) to the communica on cable (B) provided with the COM-CODE module.
- Connect the connector (C) to the machine power supply cable (F).
- If any other connec ons are required, see the M-BOX connec on diagram for RW4 Plus or FastCopy Plusor
Ezclone Plus
Connec ng to RW4 with P-BOX or FastCopy with P-BOX or Ezclone with Plus-BOX ( Fig.9)
- Connect the connectors (A) to the communica on cable (E) provided with the COM-CODE module
- Connect the connectors (B) to the communica on cable (F) provided with the COM-CODE kit for P-BOX
(OPTIONAL).
- Connect the connectors (C) to the power supply cable (G) provided with the COM-CODE module.
- Connect the connector (D) to the machine power supply cable (H).
- If any other connec ons are required, see the M-BOX connec on diagram for RW4 with P-BOX or FastCopy
with P-BOX or Ezclone with Plus-BOX.
11 Copyright Silca S.p.A 2016 - Vers.1