Herunterladen Inhalt Inhalt Diese Seite drucken

Zubehör; Sicherheitshinweise; Accessories; Safety Instructions - ELMEKO PM 100 Montage- Und Betriebsanleitung

Peltier-kühlgerät
Inhaltsverzeichnis

Werbung

ZUBEHÖR

ACCESSORIES

Bezeichnung
Beschreibung Description
Type
Netzteil Emparro 10
Emparro 10
Power supply Emparro 10
Thermostat TES60
TES 60
Thermostat TES60
Thermostat TRP 205, Heizen + Kühlen
TRP 205
Thermostat TRP 205, heating + cooling
Temperatursteuerung TRP 260
TRP 260
Temperature control TRP 260

SICHERHEITSHINWEISE

- Die Installation darf nur von autorisiertem Fachpersonal vorgenommen werden. Die landesüblichen
Richtlinien sind gemäß IEC 60364 einzuhalten
- Die technischen Daten auf dem Typenschild und in dieser Anleitung sind zu beachten
- Der Anschluss erfolgt an 24 V DC
- Anschlusskabel sind nur als Kupferleitungen zulässig
- Die maximale Umgebungstemperatur von bis zu 50 °C ist zu berücksichtigen
- Die Umgebung des Geräts darf max. Verschmutzungsgrad 2 entsprechen
- Vorschriften des EVU sind zu beachten
- Bei Beschädigung des Gehäuses oder der Anschlussleitung Spannung abschalten und alle Stecker abziehen
- Achtung! Beim Öffnen des Gerätes erlischt die Garantie
- Schutzmaßnahmen nach VDE 0100 sind sicherzustellen
- Bei der Herstellung von Montageausschnitten und Befestigungsbohrungen ist geeignete Schutzausrüstung zu
tragen.
- Luftein- und Luftaustrittsöffnungen des Gerätes dürfen nicht abgedeckt werden.
- Installation must only be carried out by qualified electrical technicians in observation of the respective national
power supply guidelines (IEC 60364)
- The technical specifications on the identification plate and in this manual, must be observed
- Supply voltage is 24 V DC
- Connection cables only as copper conductors only
- Taking into account the maximum surrounding air temperature rating of 50 °C
- The environment of the device may be maximum with pollution degree 2
- If the housing, or wire is damaged, switch off the voltage supply and disconnect all plugs
- Attention! Opening the case will void guarantee
- The safety measures according to VD 0100 have to be ensured
- Wear protective gear when cutting the mounting cut out and drilling the fastening holes.
- The air inlet and outlet openings to the unit must not be covered.
Die Entsorgung muss gemäß den jeweiligen nationalen gesetzlichen Bestimmungen erfolgen.
The disposal is to occur according to the respective national regulations.
11

SAFETY INSTRUCTIONS

Artikelnummer Part number
42 10A 500
15 TES 060
45 TRP 205
45 TRP 260

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis