Power Connection; Recharging - Denver TSP-303 Bedienungsanleitung

10. Battery shall not be directly exposed to sunshine and fire.
11. Do not attempt to replace the battery. For repairing and servicing, please consult the
store of purchase or customer service centre designated by the store.
CAUTION: Danger of explosion if battery is incorrectly replaced.
12. Do not use any other power supply other than the one specially designed for this
product.
13. Keep this operating instruction in a safe place.
14. Contact an authorized service centre if you have any inquiry about this product.

POWER CONNECTION

- Unpack this product, ensure the
power ON/OFF switch is on "OFF".
- Connect the supplied AC adaptor to
this product, plug the AC adaptor to
the wall outlet.
- Battery GREEN LED indicator will
turn to orange.

RECHARGING

- Unit comes with a battery indicator alert.
- If Battery Low LED flash, it means the
battery level is low and recharging is
required.
- By connecting the AC power, the Battery
Full LED will turn orange, it means the
unit is under recharging.
- The Battery Full LED become green, it
means the level of battery is fully charged.
It is recommended to charge the battery about 6 hours before you start using
the unit for the first time.
Energy Saving: If this product is idle for about 20 minutes, it will go to standby
mode automatically. It will auto power off.
Caution: To
rechargeable battery in good condition,
users should check the unit and be sure to
turn the Power On/Off switch on the side
panel to "Off" every time after using and
before storage, it is highly recommended
that users should
battery at least once in every two months.
keep and protect
fully recharge the
the
EN-4
POWER
ON OFF
LINE IN DC JACK
USB 1A CHARGER
MIC 1 MIC 2
POWER
ON OFF
DC JACK
LINE IN
USB 1A CHARGER
MIC 1 MIC 2