Nowsonic USB PRE PEN Bedienungsanleitung Seite 7

USB Pre Pen
GB
User manual
Operation
Turn down the VOLUME knob before connecting the headphone.
Then increase the volume while listening to the mix of the mic signal
and the already recorded tracks. Using the MONITOR knob, you can set
the balance between the microphone and the playback as needed.
NOTE: Make sure that direct monitoring via the audio software is
deactivated. Otherwise you will hear the mic signal doubled by a short
delay.
Troubleshooting
The USB indicator doesn't light
Make sure that USB Pre Pen is connected to a USB 1.1 or 2.0 port with
sufficient supply voltage.
In case of doubt use an active USB hub.
No signal in the headphones
Turn up the pre-amplification via the MIC GAIN knob.
Turn up the output level via the VOLUME knob
Set the mix balance to MIC.
The audio signal is distorted
Turn down the pre-amplification via the MIC GAIN knob.
Turn down the output level via the VOLUME knob
The source sounds delayed
Turn off the direct monitoring in the audio software.
Set the mix balance to MIC.
The headphones are not loud enough
Windows: From the „Control Panel", choose „Sound and Audio
Devices", select the „Audio" tab, click „Volume under Sound playback"
and turn up the „Volume" control.
Mac: From „System Preferences", choose „Sound", select the „Output"
tab and turn up the „Output volume".
8
www.nowsonic.com