Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
1. Mount the dual sensors at the normal water level (with the water level
reaching the lower one) on the tank/sump with the
2. Connect one tube with the pump. Plug the siphon break into tubes,
keep it higher than the water level of the reservoir, and set up the water
tube by the universal holder.
3. Connect both of the DC pump and power adapter with the controller
and then connect power.
*Please avoid setting up the sensor in an area with micro bubbles.
Caution : Risk of Injury from Strong Magnets
Air In
Water Out
DC Refill Pump
Reservoir
Siphon break must be higher than the
water level in the reservoir.
Air In :
break the siphon when the pump turns off.
Water Out :
Direction
are normal when the pump is on.
Optical Level Sensor
magnet.*
Siphon break allows air in to
Water drops out of the hole
Tank/Sump
English
Power
02
Werbung
