Display Settings - e:cue Lighting Control Engine 2 Installationsanleitung

Display settings

In the display settings you can change the contrast of the display. Use
keys to select contrast or backlight settings. Press the
dialogue
* Contrast *
Setup
Press RIGHT
*Contrast Value *
11
®®®®®
Press UP/DOWN change
* Backlight *
Setup
Press RIGHT
* Backlight Value *
ON
Press UP/DOWN change
Visible devices
These subpages show the devices attached to the system from the Device
Manager of the LAS. Use
the previous menu with . The following pages are examples.
* LCE2 I/O Inte... *
USB 33B663000000
Press the cursor key to enter the contrast
settings dialogue.
With the and
Set value with OK, return to the previous menu
with .
Press the cursor key to enter the backlight
settings dialogue.
With the and
OFF. Set value with OK, return to the previous
menu with .
and keys to select the device to display. Return to
The LCE2 I/O interface (dry contacts etc.)
The USB UID.
Setup Manual - Lighting Control Engine 2
key to enter the settings
keys change the contrast.
keys switch the backlight ON or
and
23