Inateck BCST-50 Bedienungsanleitung Seite 3

English
This is a brief version of BCST-50 manual instruction. For more detailed function
illustration, please go to www.inateck.com to download the detailed user manual or
contact us via support@inateck.com. We'll try our best to help solve your problem in
time.
If you have any problem or suggestion with our product, please contact us via
support@inateck.com.
1. Use of BCST-50
When using BSCT-50 to scan the barcode, please focus the red light on the barcode
to scan。The red light is to help the user to aim at the bar code; The white light is to
help the user to scan barcodes under the condition of insufficient light.
How to Charge
The scanner enters low-battery mode after long-beeping for 3 times, which means it
requires charging.
The required voltage for charging the scanner is 5V, and current below 1000mA.
Current controller chip is set inside the scanner to filter excessive current - for
any current above 1000mA, it filters the excessive current and inputs 1000mA for
charging. As long as the charging voltage is at 5V, the scanner should function
without issue. You can charge the scanner with a regular phone charger for the
voltage output of a regular phone charger or a laptop USB port is also 5V.
How to Start
You can power on the scanner by pushing the scan button. The indicator will flash
green when the scanner is switched on with a beep.
How to Power Off
Long press the scan button if you want to power off the scanner immediately.
How to Use
Note: When the scanner is connected both via cable and wirelessly, it transmits data
through cable by default
Wired Mode:
1. Connect the barcode scanner with computer via USB cable
2. Open a file on computer and move cursor to the blank where scanning output
should be placed. Scanning results can be displayed on computer then.
1