Maintenance And Storage; Problem Solving - Lanaform PULSE OXIMETER Bedienungsanleitung

MAInTEnAnCE AnD STORAGE

- Use a surgical spirit solution to clean the rubber part in contact with the finger inside the oximeter, and
clean this part before and after each use.
to human skin).
- Make sure you clean the OLED screen using a slightly damp cloth.
- Make sure you remove the battery from your device when you do not intend using it for a while.
PROBlEM-SOlVInG
EN
Should you encounter one of the following problems while using your PULSE OXIMETER, please consult this
guide to help you solve the problem. If the problem persists please contact your reseller.
Problems
The SpO2 and pulse measurement
display is unstable
The device does not switch on
The indicator light goes out suddenly
ADVICE REGARDInG THE DISPOSAl OF WASTE
• All the packaging is composed of materials that pose no hazard for the environment and which
can be disposed of at your local sorting centre to be used as secondary raw materials. The
cardboard may be disposed of in a paper recycling bin. The packaging film must be taken to your
local sorting and recycling centre.
10
(This part contains no toxins and is not at all toxic
Comment:
Possible reasons
Your finger is not correctly positioned
inside the device.
Position your finger correctly and
try again.
The batteries are discharged.
The batteries are not inserted
correctly.
There is a problem with the device.
The device switches off automatically
when it has not received a signal
for 8 seconds.
The batteries are almost discharged. Change the batteries.
Solutions
Position your finger correctly and
try again.
Keep still during measurement.
Change the batteries.
Reinsert the batteries.
Contact the supplier or the after
sales service.
Normal.