Installing The Hood In A Cabinet; Installation Between Two Cabinets - Electrolux EFP 6460 Montage- Und Gebrauchsanweisung

Installing the hood in a cabinet

The locking screws must be in place (x 2). If this is
not the case, the hood could drop.
1. Trace a line using the installation template to
guide you (Fig. 7.1.). Saw along this line and cut
a groove at the base of the top part of the
cabinet.
2. Measure the thickness of the cabinet walls (Fig.
7.2.). The most common wall thicknesses are
16 and 19 mm. If the thickness is any different,
choose the closest thickness.
3. Install the suspension bars (Fig. 7.2.) on the
installation template. The drawings illustrate the
left-hand side of the cabinet. Fig. A for 16 mm
cabinets and fig. B for 19 mm cabinets.
4. Push the installation template against the side of
the cabinet and secure the fastening bars with
screws (Fig. 7.3.).
5. Turn the suspension bar by half a turn when it is
installed on the right-hand side of the cabinet.
6. Raise the hood and insert the hooks in the
special slots.
7. Push the hood against the wall. Check that all
the hooks are correctly inserted in the slots.
8. Install the locking screw (Fig.7.4.).
Installation between two
cabinets
The locking screws must be in place (x 2). If this is
not the case, the hood could drop.
If the hood is to be installed in such a way that the
top edge of the front panel is aligned with the base
of the cabinet (Fig. 8.1.), follow the instructions
provided for "Installing the hood in a cabinet" with
16 mm walls, points 3-8.
If the hood is to be installed at a height above that
of the cabinet base:
1. Use the installation template to trace two
vertical lines on either side (Fig. 8.2.).
2. Measure the height at which the hood must be
installed.
3. Install the suspension bars (Fig. 8.3.).
The drawing illustrates the left-hand side. The
right-hand side is the exact opposite.
4. Raise the hood and insert the hooks in the
special slots.
5. Push the hood against the wall. Check that all
the hooks are correctly inserted in the slots.
6. Install the locking screw (see "Installing the
hood in a cabinet",Fig. 7.4.
Fig. 7.1
Fig. 7.2
Fig. 7.3
1
Fig. 7.4
Fig. 8.1
Fig. 8.2
Fig. 8.3
52
8 cm
~ 16
A
~ 19
B
2
3