Electrolux EFP 60202 Benutzerinformation Seite 68

68 68 68 68 68 electr electr electrolux electr electr olux olux olux olux installation
Installation Installation
Installation Installation Installation
W W W W W ar ar ar ar arning! Do not connect the appliance to the mains until the installation is fully ning! Do not connect the appliance to the mains until the installation is fully ning! Do not connect the appliance to the mains until the installation is fully ning! Do not connect the appliance to the mains until the installation is fully ning! Do not connect the appliance to the mains until the installation is fully
complete. complete.
complete. complete. complete.
• Pr Pr Pr Pr Preparing the wall unit - Extractor version eparing the wall unit - Extractor version eparing the wall unit - Extractor version eparing the wall unit - Extractor version eparing the wall unit - Extractor version
• The hood is supplied as an extractor unit.
Before installing the hood, drill a hole in the roof of the wall unit. This hole is to
allow passage of the outlet pipe and the power cable, and to facilitate servicing.
• The wall unit must have a minimum body depth (without door) of 280 mm.
The unobstructed internal height must be at least 370 mm.
Pr Pr Pr Pr Preparing the wall unit - Filter version eparing the wall unit - Filter version eparing the wall unit - Filter version
eparing the wall unit - Filter version eparing the wall unit - Filter version
• Before installation of the hood in the wall unit, a 115x115 mm hole for the
deflector should be cut in the ceiling of the wall unit.
• Depending on the wall unit height, you need for return air operation a pipe union
or additionally a non-flammable length of pipe (Ø 100/115/120 mm) as far as
the ceiling of the wall unit.
GB
172
190
238