Lakeland EASYSTEAM 25478 Gebrauchsanweisung Seite 10

WATER SPRAY BUTTON
Use this button to lightly spray your fabric with water on really stubborn creases. It can be
used when you are ironing with or without steam.
Aim the spray nozzle at your fabric and press the water spray button a couple of times to
dampen the fabric with a fine mist of water, then iron.
Delicate synthetic fabrics should be ironed without steam, but can be sprayed.
AUTO SHUT-OFF
• The iron will automatically switch off when the iron is not moved and still switched on
at the plug. This is a safety feature.
• The iron will switch off automatically if left in a downwards position or left on its side
and not moved for 30 seconds. If left sat on its heel in a vertical position it will switch
off after 8 minutes.
• The pilot light will flash to show the iron is in 'Auto Shut-Off' mode.
• The iron will automatically switch on when it is moved.
• The pilot light will come on until the iron has reached temperature again. This can take
up to 60 seconds.
SWITCHING OFF
When you have finished ironing, place the iron on its anti-slip heel, move the steam
control slider to 'No Steam',
down completely.
10
Water spray button
turn off at the socket and unplug. Leave the iron to cool
• After every use, empty the water tank.
• Open the water tank cover and drain the water from the
tank into a sink.
• Close the water tank cover.
• Always store the iron standing upright on its anti-slip
heel in a safe, dry place, with the tank empty and
soleplate cooled.