Removing The Blade - Team International TEAM AS 1 M Gebrauchsanleitung

Fax +32 2 359 95 50

IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the maximum usage time).
The breaks should last at least 10 minutes.
USING THE SLICER
For a safe use, your appliance is fitted with a complete device (platform (4) with a thumb
guard (6) and pusher (3)) which allows to protect your hands by giving an exceptional use
comfort.
The platform allows to make to and fro motions along the blade to cut the slices. Use the
handle to move it.
The pusher allows you to keep the food when slicing by holding your hand far from the blade.
Therefore it is recommended to always use it except if the food is too large and in this case
keep it as far as possible from the blade.
 Clean all parts of the appliance before the first use.
 Make sure the appliance is steady and add the pusher (3) on the platform (4).
 Plug in the appliance. The slicer is now ready for use.
 Place a plate or a dish behind the blade to collect the slices.
 Free the platform from the blade and lay the food to be sliced on its stainless steel plate.
 Push the food against the mobile side of the appliance with the pusher (3) and select the
slicing thickness by turning the adjusting knob (5).
 Place the switch (2) to the position I. The blade will start rotating and the pilot light of the
switch goes on.
Push the platform to bring the food to the blade (1). Therefore use the handle of the

platform and keep the pressure on the mobile side of the appliance thanks to the pusher.
 If it becomes difficult to slice the food (important braking of the blade), move back a little
bit and start the operation again by approaching the blade slowly.
 To avoid food sticking to the appliance and to improve the slicing, you can moisten or oil
the blade with a wet towel beforehand.
 Do not slice meat with bones, food with large seeds, rolled roast without removing the
string, wrappers (i.e. aluminium foil), frozen food or any hard, inedible food parts.
CLEANING
 The switch has to be in position OFF and the appliance has to be unplugged from the
power supply before cleaning the appliance
 Wipe the inside and outside of the appliance with a paper towel or a soft cloth. It should
not be washed in a dishwasher (the platform tips to make the cleaning easier).
 Do not clean the inside or outside with any abrasive scouring pad or steel wool as this will
damage the finish.
 Do not immerse in water or any other liquid.
 Dry all parts well before storage.

REMOVING THE BLADE

 To clean the appliance thoroughly, it is possible to remove the blade.
 Always switch off the appliance and unplug it from the power socket before removing the
blade.
 To do so, loosen the three screws (with a cross-head screwdriver).
 Make sure you replace the blade in its exact original position after cleaning.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
7
Assembly page 7/24
TEAM AS 1 M - 070420