Temperature Alarm; Settings; Activating The Child Lock; Adjusting The Display Brightness - V-ZUG UC SL60 Bedienungsanleitung

Temperature alarm

If the temperature inside the appliance falls below or exceeds the
set temperature significantly, a temperature alarm sounds and
the temperature display flashes. The temperature alarm can be
triggered if the door is not closed properly, due to a lengthy power
failure or if the appliance is defective. For this reason, first check
that the door is closed properly.
• Cancel the audible warning signal by pressing the
After a power failure, the temperature display stops flashing and
lights up again once the set temperature has been reached. If the
display continues to flash and show a value that is too high or too
low after one hour, contact the customer service department. If
F1, F8, E1, E2, E7 or E8 appears in the display, the appliance
has suffered a fault. In this case, contact the customer service
department.

Settings

You can set the child lock and adjust the brightness of the display
via the settings. You can protect the appliance against being
switched off accidentally and prevent the temperature from being
changed using the child lock.

Activating the child lock

Press for 5 seconds. Display =
Display =
Display =
Display =
EN-06
Deactivating the child lock
Press
button.
Display =
Display =
Display =

Adjusting the display brightness

Press
Display =
Display =
Use buttons
h0 = display lighting off
h1 = minimum brightness
h5 = maximum brightness
Display =
Display =
The adjusted brightness will be activated after one minute.
Note
If a button is pressed, the display lights up for one minute at
maximum brightness.
When commissioning the appliance, the adjusted brightness will
only be active once the set interior temperature of the appliance
has been reached.
for 5 seconds. Display =
for 5 seconds. Display =
and to select the desired setting.