Klauke Textron mini EK 15/50 Bedienungsanleitung Seite 35

Instruction Manual Crimping Tool
EK 15/50, EK 15/50G, EK 35/4
Attention
Do only crimp copper and Al conducting material or special connecting material mentioned in table 2 and 3.
If different conducting materials have to be crimped, please contact the manufacturer.
Our EK15/50 and EK15/50G can also be operated with numerous different dies. A list of standard dies can be found
in our general catalog chapter „Dies" and here pic. 2 and 4.
Attention
Do not crimp on live cables or conductors
Before starting to crimp please make sure that all parts involved in the crimping process are not connected to live
circuits.
The tools are a hand held tools and they are not supposed to be restrained in a vise. It is not allowed to use the tools
in a stationary application.
The tool is not designed for continued crimping operations. After a sequence of approximately 100 completed crimps
you have to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of electric engines sparks can occur which might ignite highly infl ammable or explo-
sive liquids and materials
Attention
Electric-hydraulic crimping tools should not be operated in pouring rain or under water.
HE.9446_L © 12/10 9
GB