Packing And Unpacking; Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply - Nilfisk cfm T22 Plus Betriebsanleitung

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
Figure 3
MODEL
T22 Plus
L
50L M
H
100L L
MODEL
T40 Plus
L
50L M
H
100L L
MODEL
T40W Plus
L
50L M
H
100L L
[ NOTE ]
Model T40WPLUS H AA for vacuuming asbestos, TRGS
519 regulation.
This model complies with all the technical data of model
T40WPLUS H.

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight.
09/2014
A B C
kg
(mm) (mm) (mm)
165
1350 700 1805 168
170
1350 700 1805 168
A B C
kg
(mm) (mm) (mm)
189
1350 700 1805 191
194
1350 700 1805 192
A B C
kg
(mm) (mm) (mm)
194
1350 700 1805 196
199
1350 700 1805 197
T22 Plus - T40 Plus - T40W Plus
Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
Before plugging the vacuum cleaner into the
■
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the connection
cables must be protected against splashes of
water.
■ Check that for proper connection to the electrical
mains.
■ Use the vacuum cleaners only when the cables
that connect to the electrical mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or ageing on the electric
cable.
WARNING!
When the vacuum cleaner is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
Only disconnect the cable from the electrical
■
mains by removing the plug (do not pull the
cable).
■ Only replace the electric power cable with one
of the same type as the original: H07 RN - F. The
same rule applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
5
GB
C380