Measuring - I.E.M. Tel-O-Graph GSM Gebrauchsanleitung

5.4

Measuring

WARNING!
Risk of injuries during measurement!

Do not place the air tube around your neck.

If you feel any pain during the measurement,
stop the measurement.

Do not place the cuff over wounds.
1) Apply the cuff and assume the correct posture.
– button.
2) Press the
 The display shows the start screen (Fig. 5).
– button again to start the
3) Press the
measurement.

The monitor confirms this with a short acoustic
signal. The cuff slowly pumps up. After the initial
pumping, there is additional pumping. Once the
monitor detects a pulse, the icon ♥ appears. The
reading is taken as the air is let out.
Measuring blood pressure and pulse
i
During a pulse reading with the
®
Tel-O-Graph GSM plus, the cuff pressure
will be kept constant during the air release
for 10 seconds at the diastolic blood
pressure value to enable the pulse wave
form to be read.
i
Do not talk during the measurement.
You can stop the measurement at any
time by pressing the
After the measurement, all the air is let out of
the cuff. The display shows your blood
pressure and your pulse rate.
4) Check the results.
5) Remove the cuff.
EN
– button.
61