Sony UPA-PC105 Bedienungsanleitung Seite 24

Message
PAPER TAG ERROR tCannot read the information from
RESERVE
RIBBON END
RIBBON TAG
ERROR
UNKNOWN ERROR tAn error of unknown cause
24
GB
Troubleshooting
Meaning/Solution
the IC seal on the paper loaded in
the printer.
Replace the ink ribbon and paper in
the printer with new ones.
tThe printer may be off line.
Confirm that the printer is not off
line, then touch the [Retry] button.
If the same message appears again,
touch the [Cancel] button to cancel
the operation, shut down the
system, then switch the main unit
and printer off and on.
tThe ink ribbon loaded in the printer
exceeded the specified number of
prints.
Load the allowed number of sheets
in the printer and install a new ink
ribbon.
tThe ink ribbon loaded in the printer
exceeded the specified number of
prints during printing.
Touch the [OK] button to stop the
print job. Load fresh paper in the
printer and install a new ink ribbon.
tCannot read the information from
the IC seal on the ink ribbon loaded
in the printer.
Replace the ink ribbon and paper in
the printer with new ones.
occurred.
Confirm that the connections at the
unit and printer are secure, then
touch the [Retry] button. If the
same message appears again, touch
the [Cancel] button to cancel the
operation, shut down the system,
then switch the main unit and
printer off and on.
Photograph Scannning Error Messages
For more details about using the unit connected with a
scanner, refer to the instructions accompanying the
scanner.
Message Meaning/Solution
tAn error occurred during
SCANNER ERROR
communication between the unit
and the scanner.
Confirm the following:
• Scanner is on.
• USB cable connected correctly.
Touch the [Retry] button. If the
same message is displayed again,
touch the [Cancel] button to cancel
the operation, then shut down the
system and switch the main unit
and scanner off and on.
Film Scanning Error Messages
For more details about using the unit connected with a
film scanner, refer to the instructions accompanying the
film scanner.
Message Meaning/Solution
tAn abnormal condition inside the
AF_ERR
film scanner caused an error.
Touch the [Retry] button to
continue the scanning job. If the
same message appears again, touch
the [Cancel] button to cancell the
operation, shut down the system,
then switch the main unit and film
scanner off and on.
tA slide remains inside the carrier of
CHG_RST_
CARRIER the film scanner.
Touch the [Retry] button then
remove the slide.
tAn abnormal condition in the
CHG_RST_
CHANGER changer carrier of the film scanner
caused an error.
If the same message appears again
after touching the [Retry] button,
touch the [Cancel] button to cancel
the operation, then shut down the
system and switch the main unit
and film scanner off and on.
COVER_OPEN tFilm scanner cover is open.
Close the film scanner cover.
tFilm jammed inside the film
FILM_FEED
scanner.
Touch the [Retry] button, then
remove the jammed film.
tFilm is still set in the film scanner.
FILM_IN
Remove the film from the film
scanner.
tFilm jammed inside the film
FILM_JAM
scanner.
Touch the [Retry] button, then
remove the jammed film.