Setting The Alarm Time - Bering 91066 - 22S Bedienungsanleitung

EN

SETTING THE ALARM TIME

Set the desired alarm time using the alarm time setting wheel (2) at the
back. (Note the direction of the arrow). (Turning the alarm time setting
wheel in the opposite direction to the arrow does not always set the alarm
time). In order to set the alarm, push the side switch (4) upwards, a red field
becomes visible.
SETTING THE ALARM SIGNAL / SNOOZE
Briefly press the snooze/light button (3) The alarm signal will be interrupted
for 4 to 5 minutes and will sound again afterwards. The snooze function can
be repeated as often as desired for a period of approx. 60 minutes. If the
alarm is not interrupted or switched off, it automatically stops after about 2
minutes. It sounds again 12 hours later at the set alarm time. To turn off the
alarm completely, slide down the side switch (4).
LIGHTING:
In order to start the light function, the alarm clock must receive the time
signal first. The dial illumination of your alarm clock is automatically swit-
ched on for 5 seconds with each alarm signal. Every time the upper button is
briefly pressed (3) the lighting switches on for 5 seconds.
alarm on/off switch (4)
alarm time setting wheel (2)
battery cover (1)
EN
light / snooze /
time zone (3)
alarm time
+ 1,5V — LR6 –
---