Asus ROG AURA TERMINAL Schnellstartanleitung Seite 11

Using Halo
Before using Halo, download the Halo software from
the ASUS website www.asus.com, and ensure to
stick your addressable RGB strips to the rear of your
monitor*.
* Each edge of the monitor must be mapped to an LED strip
powered by a unique channel.
The built-in lighting effect and Aura is disabled when Halo software is active, ensure to
disconnect from Halo Software when you wish to enable the built-in lighting effect or
Aura.
Lighting
devices
Set lighting
brightness
Click on an LED
to disable or
enable it on the
addressable RGB
strip
ROG Aura Terminal
Q13951_ROG_AURA_TERMINAL_QSG.indb 11
Enable or
disable Halo
lighting effect
Set addressable
RGB strip header
Set Halo screen
detection ratio.
Hot Key for Auto
mode: Ctrl + PrtSc
Check all LEDs
Allows you to
reverse the
lighting effect
11
5/22/2018 3:44:10 PM