Sony WRT-822A Bedienungsanleitung Seite 7

1 Display section
A B
A AF (audio input) indication
Lights when an audio signal over the reference level is being
supplied.
B RF (antenna output) indication
Lights when a signal is being transmitted from the antenna.
C BATT (battery) indication
Displays the status of the batteries.
See "Battery indication" on page 7.
D CH (channel) indication
Displays the transmission channel.
Each time you press the SET button in normal Transmit
mode, the channel indication changes to the frequency, input
attenuation and accumulated time indications as shown in
the right column.
C
Display example for
D
CE62 model
Channel indication
Accumulated time
indication
In Attenuation indication mode, it displays the input
attenuation setting in dB, which can be changed in a range
of 0 to 21 dB in 3-dB steps.
In Accumulated time indication mode, it displays the
accumulated time of battery use (in one-minute increments).
For adjustments, see "Changing the Transmitting Channel"
on page 9, "Changing the Input Attenuation Setting" on page 12
or "Resetting the Accumulated Time Indication" on page 12.
2 + (+ selection) / – (– selection/reset) buttons
In setting mode, select the transmission channel, frequency
and attenuator level using either of these buttons, or reset the
time-of-use indication to "00:00" with the – button.
For Setting mode, see "Settings" on page 9.
Frequency indication
Attenuation indication
Display example for CE62 model
5
GB