Settings; Initiating Setting Mode; Changing The Transmitting Channel - Sony WRT-822A Bedienungsanleitung

Settings

Initiating Setting Mode

In Setting mode, you can change the transmission channel/
frequency and the attenuation level, or reset the accumulated
time indication.
To enter Setting mode
While holding down the SET button, set the POWER switch
to ON.
The transmitter enters Setting mode and the indication
before the transmitter was previously turned OFF flashes on
the display section.
Each time you press the SET button, the setting items are
cyclically switched as shown below.
Group selection Channel selection
Accumulated time
indication reset
Frequency selection
Attenuator
adjustment
Display example for CE62 model

Changing the Transmitting Channel

To change the group selection
1
After setting the unit in Setting mode, press the SET
button so that the group indication flashes.
In group selection mode
2
Press the + or – button to select the group.
Pressing the + button cyclically changes the group
indication in the order of "Overview of Channel Plan"
tables (page L-1).
Pressing the – button changes it in the reversed order.
If you hold either button pressed, the group setting will
change successively.
For the CE62 model, the indication will cycle from group
00 through 63 as shown on next page.
Display example for CE62 model
GB
9