EuroLite LED Bar 2 RGBA 252/10 Bedienungsanleitung Seite 23

Controlling:
After having addressed the LED Bar 2 RGBA 252/10, you may now start operating it via your lighting
controller.
Note: It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.
Addressing
Press the MODE button until the display shows DMX512 MODE.
Press the ENTER button and the display shows: 001.
Set the desired address via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
DMX Channel Selection : Choosing a DMX Channel Mode up to 19 Channal Occupation
After having set the desired addresses and pressed ENTER, you can now choose a DMX Channel Mode. (4
CH, 6 CH, 19 CH).
Set the desired mode via the UP or DOWN buttons.
Press the ENTER button again to confirm and to exit the DMX Mode.
Please see the following DMX protocol graphics for the respective channel values.
4-Channel Mode:
CH 1 CH 2
Red Green
(0 - 255) (0 - 255)
6-Channel Mode:
CH 1 CH 2
Red Green
(0 - 255) (0 - 255)
CH 3 CH 4
Blue Amber
(0 - 255) (0 - 255)
CH 3 CH 4
Blue Amber
(0 - 255) (0 - 255)
23/26
CH 5 CH 6
0: On
Master
1 - 5: Sound control
Dimmer
6 - 10: On
(0-255)
11 - 255: Flash
00058952.DOC, Version 1.2