Werbung
Verfügbare Sprachen
Verfügbare Sprachen
19712 iPad Stand Holder
- Strength and stability! A clever way to show off your iPad.
- The new mount guarantees to hold the iPad effectively and safely.
- For use on stage, in the rehearsal room or at home
- With thread for microphone stands (3/8" or 5/8").
- The iPad is clipped in and out of the holder effortlessly.
- An easy-to-use wing nut adjusts the tilt so the user can easily find a position to suit them.
- The iPad can rapidly switched between the vertical an horizontal format, whereby slip is
-
prevented.
Thank you for choosing this product. This instruction manual informs you about the important steps to set
up an handle the product. We recommend to keep the manual in a separate place for a possible later use.
SAFETY INSTRUCTIONS
- suitable for iPad 2nd, 3rd or 4th Generation, not suitable for iPad 1st Generation
- Use suitable stands w.stability, support, centric loading and connector-thread,
-
e.g. any KÖNIG & MEYER - microphone stand
- clip in the iPad carefully and check the correct positioning
- handle with care, particularly while changing the setting (tilting, vertical/horizontal format)
MOUNTING INSTRUCTIONS
The iPad 2 stand holder is very easy to attach.
Use a suitable stand (see SAFETY INSTRUCTIONS)
1 first screw on the disc (3/8", 5/8") to the stand
1
until stop
2 then screw the iPad stand holder onto the stand
3 tighten iPad stand holder with the disc
4 tighten wing nut
5 place iPad into the holder-plate and
6 clip in the iPad at last.
For removal please notice reverse order.
USERS TIPPS / DIMENSIONS
SETTINGS - Tilting & Format (vertical/horizontal)
The iPad can remain in position.
TILTING
Choose any angle between 0-90°.
7 Hold the iPad and loosen wing nut
8 Tilt iPad into desired angle and
9 Tighten wing nut again
FORMAT
The iPad can be rapidly switched between
the vertical and horizontal format.
10 turn holder-plate into desired format
10
- or into slant !
10
Invisible mechanical stops limits the adjustment
TIPP
Beware of the position of the on/off-switch
11.a - at the bottom
11.b - on the right side.
Effect: due to the mechanical stop inside of the holder
the cord of a head phone set couldn´t cause a rotation.
(FF) FAULT FINDING & (R) REPAIR
FF: holder wobbles
FF:
R: Tighten stand-holder-screwing (see mounting
FF: R:
instructions 1-3)
FF:
R: Tighten wing nut 4
FF: iPad wobbles
FF:
R: Lock in place iPad correctly 5 - let´s hear the "click"
FF: R:
noise 6
FF:
R: Note the correct position of the iPad 11.a, 11.b
FF:
R: ATTENTION! Not suitable for iPad 1st Generation.
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
19712-300-55 / 19712-500-55 Rev.10 03-80-127-00 6/13
TECHNICAL DATA
swivel joint, holder-plate: Polyamid (PA-6)
Material
screws, nuts, washers, springs: steel
Max. load
iPad 2nd, 3rd or 4th Generation
base dimensions: 252.1 x 104.8 x 195.4 mm
Size
card box: 300 x 102 x 230 mm
Weight
net 0.54 kg, gross 0.82 kg
Werbung
