Technical Specifications - Maestro MR560 Bedienungsanleitung

Technical specifications

Model MR560
Electrical supply:
Alternating current- AC;
Rated voltage 220-240V;
Rated frequency 50Hz;
Power consumption 500W
Number of operative speeds: 6
Protective class II
Protection class IPX0
Regime of operation: continuous operation during max. 5min.,
pause during at least 10 min. to complete cooling.
Description of the appliance
Picture1 (page 2)
1. Off switch/interchanging switch of velocities.
2. Cup (bowl)
3. Protective hood of the cup with loading orifice.
4. Motor box.
5. The position (inclination) fixing mechanism of the mixer.
6. Wire whisks.
7. Flat beater.
8. Dough hook.
9. Case.
10. The blade for cleaning and extraction of the ready mass of the
product.
Safety instructions
When using your appliance, basic safety precautions should
always be followed, including the following:
4
SPECIAL INSTRUCTIONS
ATTENTION!
NEVER immerse the electric drive case, cable or plug in any liquid.
NEVER touch the appliance with wet or damp hands.
ALWAYS disconnect appliance before cleaning, assembling,
disassembling, loading and unloading products
Failure to observe these rules may result in electric shock!
- DO NOT let children or untrained persons use the appliance
without supervision.
- DO NOT leave the appliance unnecessarily plugged in. Disconnect
the plug from the mains when the appliance is not being used.
- DO NOT use the power cord or the appliance in order to pull the
plug out of the socket.
- DO NOT leave the appliance exposed to the weather (rain, sun,
etc. ).
- DO NOT leave the appliance without supervision when it is
connected to the power supply.
- Close supervision is necessary when the appliance is used near
children.
- Always unplug from the plug socket when not in use and before
cleaning.
- Do not operate the appliance if damaged, after an appliance
malfunctions or it has been damaged in any manner, return to at
authorized service engineer for repair.
- In the interest of safety, regular periodic close checks should be
carried out on the supply cord to ensure no damage is evident.
Should there be any signs that the cord is damaged in the slightest
degree, the entire appliance should be returned be authorized
service engineer.
- Do not let the cord hang over the edge of a table or counter or
EN
5