Werbung
Verfügbare Sprachen
Verfügbare Sprachen
leaning position. (pict. G-1)
-
The front passenger´s seat should be set in the farest back position.
-
Pull maximally the car´s seatbelt and put its hip part through the upper
slot meant for the hip safety belt (pict. C)
-
Buckle the safety belt
-
Put the chest part of the car´s seatbelt through the slot meant for the
chest safety belt, which is located at the back of the carseat´s shell (pict.
D)
-
Set the car seat´s holder in a "Blocked " position.
-
NOW the Berber Carlo children´s car seat is properly installed.
III.
Regulation of the carseat´s holder
In order to change the holder´s position forwards or backwards, you should press
buttons situated on both sides of the car seat, at the same time.
The buttons will go back to their initial position as soon as the proper position of
the holder is found.
There are four positions of the holder (pict. G)
1.
Car position
2.
Carrying position
3.
Sleeping/Rocking position
4.
Sitting position / carry cot
In order to find a neede position of a holder:
-
Using both hands press two blue buttons which regulate the position of
the carseat´s holder (pict. G)
-
Move the holder to the position you require, unitl you hear a loud and
clear "click" sound, which is the sound of snapping shut.
IV.
Cleaning of the Berber Carlo children´s car seat:
1.
Cleaning and maintenance
-
the shell of the car seat may be cleaned with warm soap water
-
the upholstery my be handwashed in a temperature below 30°C
-
DO NOT tumble dry
2.
Taking off cover
-
unfasten the main safety buckle
-
take out the shaping insertion
-
put the braces and the crotch belt through the holes in the cover
-
take off the cover
14
Werbung
