General Information - HOESCH SteamSet Montage- Und Bedienungsanweisung

Index
01 Allgemeine Hinweise...............................................................................................................................................3
02 Aufstellplatz/Aufstellraum Duschwanne und Duschabtrennung .............................................................................4
03 Allgemeine Pfl egehinweise .....................................................................................................................................4
03.01 Pfl egehinweise Scheiben und Profi le......................................................................................................................4
03.02 Pfl egehinweise Armaturen ......................................................................................................................................4
03.03 Benutzen Sie keine... ..............................................................................................................................................4
04 Arrangement examples ........................................................................................................................................ 19
05 Installation ........................................................................................................................................................... 20
01

General information

Hoesch products set the benchmark for quality, comfort and design. To assure optimal function and a long life cycle
of your product please comply with the following instructions. Each delivery is strictly controlled before leaving
the factory. Check the completeness of the delivery before starting installation. Products represented here are subject
to technical and visual modifi cations! All dimensions data is in mm. All connection measures are internal measurements!
We are not liable for defects resulting from non-conventional usage, improper transport or faulty intermediate storage.
Our respectively valid warranty conditions are in force.
During mounting protect the surface of shower tray with cover!
Do not put glass panes on rims or corners!
Caution! Check the delivery for transport damage! Later claims will not be accepted!
The choice of raw plug and screws depends upon the wall's material!
■ Water connections
At installation to potable water supply plumbers or users must connect fi rst a safety device complying with
national requirements.
Wall joints must be sealed with non-hardening joint sealing. The device mus be fl ushed with water according
to DIN 1988. For domestic installation a dirt trap shall be provided by the user.
■ Electrical installation
For electrical connection (230V / 50Hz, 16 A)an appropriate supply cable, 3x2,5mm² should be used.
The device must be protected by a separate FI-switch / RCD (30mA), which disconnects the system
by a contact gap of min. 3 mm width.
We strongly recommend to connect the system to mains electricity via an all pole disconnecting switch
(16A, min. 3 mm contact gap, please pay attention to protection areas).
The device must be connected to the electricity network via an all pole disconnecting switch according
to electrical installations regulations.
Note: All electrical work must be performed by a qualifi ed electrician in accordance with DIN/EN
specifi cations (DIN VDE 0100-701, etc.), national regulations and local EVU regulations!
Installation and repair should be performed only by authorized service. It should be noted that a backflow protection
device willingly (EN61770) (VDE 0700 Part 600) in water connection must be provided by the user.
GB
5