Tuning To Radio Stations - Philips AZ 1565 Bedienungsanleitung

Tuning to radio stations

1. Select TUNER source.
™
is displayed briefly and then the radio station
frequency is shown.
2. Press BAND once or more to select your waveband.
3. Press SEARCH ∞ or § (on the remote control, TUNING ∞
or §) and release when the frequency in the display starts
running.
™ The tuner automatically tunes to a station of sufficient
reception. Display shows
™ If an FM station is received in stereo,
4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press SEARCH ∞ or § briefly and
repeatedly until you have found optimal reception.
To improve radio reception:
• For FM , pull out the telescopic aerial.
Incline and turn the aerial. Reduce its length if the signal is
too strong (very close to a transmitter).
• For MW (LW) , the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning the
whole set.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
™ Display:
flashes.
PROG
3. Press PRESET 3 or 4 once or more to allocate a number from
1 to 30 to this station.
4. Press PROG again to confirm the setting.
™ Display:
disappears, the preset number and the frequency
PROG
of the preset station are shown.
5. Repeat the above four steps to store other stations.
• You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press TUNER PRESET 4 or 3 until the desired preset station is
displayed.
during automatic tuning.
is shown.
STEREO
AZ 1565/00
page
DIGITAL TUNER
7
7