Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Montage - IDEAL 4605-Cross/Cut Betriebsanleitung

Inhaltsverzeichnis

Werbung

INSTALLATION

a) Loosen the 4 screws holding the
machine on the pallet with the help of a
wrench (13 mm).
b) Use several strong people to lift the
machine from the pallet. Then roll the
machine to its destination (Attention: Do
not lift the machine by the hopper).
Important: Machine should only be instal-
led in a dry location.
c) Open the door H. Remove the waste
bin 0 and put a plastic bag in, folding the
bag end over the top of the waste bin 0.
Then push the waste bin into the cabinet.
Close the door, otherwise the machine will
not function for safety reasons.
d) Raise the feeding table F so that the
air slits G are open.
e) These machines come with a Cekon-
plug. If a corresponding Cekon-socket is
not available, it should be installed by a
trained electrican: 3-phase A/C power -
voltage as per specification sticker. Circuit
protection: 16 amp. slow blowing (230
Volt-Version: 30 amp. slow blowing).
f) After reading the operating instructions
slide them into the holder inside the door.

MONTAGE

a) Dévisser les 4 boulons de la palette
avec une clé de 13 mm.
b) Après déballage, retirer la machine de
la palette à plusieurs, et la rouler jusqu'au
lieu d'installation (Attention: Ne jamais
soulever la machine par l'entonnoir).
Important: La machine ne doit pas être
utilisée en endroit humide.
c) Ouvrir la porte H. Retirer le chariot à
déchets 0 et y introduire un sac plastique
en le rabattant sur les bords du chariot à
déchets 0. Replacer ensuite le chariot à
déchets dans son logement en le pous-
sant vers l'avant. Fermer la porte, sinon le
destructeur, pour des raisons de sécurité,
ne fonctionnera pas.
d) Remonter la tablette F pour libérer
les aérations G.
e) Ce destructeur est équipé d'un moteur
triphasé. Les caractéristiques du moteur
se retrouvent sur la plaque signalétique
de la machine. Le secteur doit être
protégé par des fusibles de 16 ampères à
fusion lente en version 400 Volts (Version
230 Volts: 30 ampères à fusion lente).
f) Après consultation, ranger le mode
d'emploi dans son emplacement derrière
la porte.
-11-

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

4605

Inhaltsverzeichnis