Charging The Battery - Tack life PCD05B Bedienungsanleitung

WARNING
Failure to follow the correct procedure when charging batteries will result in
permanent damage.
Note
Normal charging time is approximately 3-5hr for a recently discharged 1.5Ah
capacity battery. However, if the Battery has been left in a discharged state for some
time, it may take additional time to charge.
1. Slide a fully or partially discharged Battery on to the Battery Charger .
Note
Make sure the Battery and Battery Charger are lined up correctly.
If the Battery does not slide on to the Battery Charger easily, don't
force it. Instead, remove the Battery, check the top of Battery and
the Battery Charger slot are clean and undamaged and that the
contacts are not bent.
2. Once charging commences, the Red LED will on
3. When the Battery is fully charged, the Red LED will off and Green LED will on.
Battery Charge Level
The Battery has a built-in Battery Charge Indicator.
Pressing on the button to the right will indicate the charge level. The right LED
indicates a high charge level and the left a low charge level that will mean the battery
pack will require charging soon.
MPORTANT
When a low charge level is indicated, the tool may stop operating while in use, which
is dangerous when operating a circular saw. Always ensure the battery pack has a
good charge level.
Note
about battery charging:
● The battery should be charged at ambient temperatures between 10 and 40°C
(ideally around 20°C).
● After charging, allow 15 minutes for the battery to cool before use.
● Ensure that the charger is disconnected from the mains supply after use, and is
stored correctly.
●
DO NOT leave batteries on charge for extended periods and NEVER store batteries
on charge.
●
The Battery Charger monitors battery temperature and voltage while charging.

Charging the battery

- 10 -