Installation Orientation - Sun Hydraulics XMD-01 Installationsanleitung

Installation Orientation

1. The controller should be mounted to a flat surface.
2. The bracket can be mounted horizontally or vertically.
3. Provide sufficient clearance from moving parts.
4. Do not mount in a location that will result in ambient temperatures greater
than specified operational temperature limits.
This equipment has not been investigated as a safety rated com po nent
and shall not be relied upon as a safety device. Separate emergency
stop equipment must be integrated on the machine in accordance
with the machinery directive. The operator of the equipment shall
always be in sight of the controlled machine and be prepared to use
emergency stop equipment if any malfunction occurs.
10
NOTE: Dimensions are in
inches (mm)
© 2017 Sun Hydraulics Corporation
Pub.#999-901-853 November 2017
www.sunhydraulics.com