Harness Labelling; Harness Inspection - Simarghu FIRE Bedienungsanleitung

7. HARNESS LABELLING

CE Mark
1
EN Standards
2
3 Manufacture
4 Max Load
5 Product Reference
6 Serial Number
7 Date of Manufacture
Read Manual
8
QR Code
9
Size Guide
10
9
EN358: 2000
2
EN813: 1997
8
1
POSITIONING ONLY! - NOT FOR FALL ARREST
MAX LOAD: 120KG
MODEL: SIMFIRE ARB-1
SN: ARB1-000000
DOM: 0317
S/M

8. HARNESS INSPECTION

REGULAR CHECKING AND RECORD KEEPING
This harness and all other equipment must be visually inspected
by a competent individual when delivered to site, and thoroughly
inspected before and after every use. If you are unsure or have
any doubt about the condition of the harness you MUST
remove it from service.
A record card is included with this manual and should be filled
in after each routine inspection. Registration and record keeping
can also be completed online by visiting www.simarghu.com/
register and entering the product's unique serial number.
THOROUGH INSPECTION IS TO BE GIVEN TO EACH OF
THE FOLLOWING KEY AREAS:
Examine for cuts, cracks, tears, abrasions* and scorch
WEBBING
marks, burns or chemical attack.
STITCHING
Look for broken stitches, lose or worn threads.
3
Inspect for any signs of damage, distortion, or corrosion
METALWARE
as well as ensuring correct operation.
4
5
LABELLING
Ensure all label information is still legible.
6
7
10
*Common abrasion wear within webbing may be caused by passage over
sharp edges when under tension which may result in serious weakening. Slight
damage to the outer fibres and threads could be considered harmless; however
serious damage such as reduction of the thickness or width of webbing should
lead to rejection and immediately removed from service.
UK
13