Troubleshooting - RCG RB 030 P Bedienungsanleitung

5. You can always tune in the stored presets by pressing shortly SET when the radio is on.
6. To edit the list of your saved stations, tune to the newly desired station and repeat steps 2 to 4 The originally
saved stations will be overwritten.
Using function falling asleep with music
1. Press twice RADIO/SLEEP (A4) to enter falling asleep with music mode. The display fl ashes the falling
asleep symbol "L" and the set interval "05" (5 minutes).
2. Press repeatedly RADIO/SLEEP to set as required the falling asleep with music interval to 15, 30, 45, 60,
75 or 90 minutes.
3. When the display switches back to time display, you can display the remaining time to shutoff by pressing
shortly RADIO/SLEEP.
4. The radio will play for the set time and then automatically shuts down.
5. If you want to turn off the radio before the set interval, press once
GB
Using the projection function
Press shortly the button
When the projection is on, you can hold the button
On the rear side of the device is a knob (C8), with which you can rotate the projected time by 90°.
AUX input and playback music from your smartphone or MP3 player.
You can connect your telephone to radio alarm clock, tablet or MP3 player via AUX input (C5) and play
music stored in the memory of these devices.
1. Using audio cable connect the connector AUX Line-in (C5) on the rear of the radio alarm clock to the
headphones connector on your phone or on an MP3 player.
2. Play the desired music from the player.
Note: When you connect the cable to the connector AUX it is not possible to use the radio function and adjust
the volume. Adjust the playback volume on the connected device.
USB connector for charging mobile phones
You can use the USB connector CHARGE OUT (C6) to charge your phone.

TROUBLESHOOTING

If your radio alarm clock shows incorrect time or does not function properly, which could be caused by static
electricity or other interference, unplug the power connector (C4) from the DC outlet (C3) and remove
the backup battery (C2). The device will be reset to default settings and you will need to set it again.
MAINTENANCE AND CLEANING OF THE DEVICE
Unplug the system before cleaning.
• Place the device on a fl at surface protected from direct sunlight or excessive heat and humidity.
• Protect glossy furniture or furniture made of wood using a tablecloth or other protective materials
between the furniture and the device.
• If the unit is not used for longer period, remove the batteries to prevent leakage and subsequent corrosion.
• Clean the surface of the device with a soft, dry cloth or lightly moistened with a mild detergent solution.
Prevent moisture penetrating the device.
• Do not use cleaning agents containing alcohol, ammonia or abrasive ingredients.
28
(A2) on the left side of the device to switch on or off the projection function.
to turn the projected time upside down.
(A5).