Using The System - RCG RB 030 P Bedienungsanleitung

• The appliance does not operate normally in accordance with the manual. Set only the elements
described in the operating manual.
• The device shows signifi cant functionality changes, indicating need for service.
• Do not expose the device to heat sources such as radiators, heating or other heat-producing appliances
such as amplifi ers.
• Changes or modifi cations not expressly approved by the responsible authority can lead to loss of
authorization to use the device.

USING THE SYSTEM

Installation
Connect power adapter (C7) to the electrical outlet and to DC connector of the adapter. (C4) connect to
the DC 5.5V jack (C3). Radio alarm clock is now ready to use.
GB Installation of backup battery
You need for backup power of the radio alarm clock lithium battery CR2032 (not included) in case of power
failure of the power grid.
1. Place the device on an even surface.
2. Remove the battery space cover (C1).
3. Insert new CR2032 battery in the battery space (C2) with the symbol + upwards as marked.
4. Replace the battery space cover.
If there is a power failure, the LED display goes out and the radio or alarm clock will not function during the
power outage. The new backup battery retains clock settings and other device settings for approximately
3 days. Ensure that a new lithium battery CR2032 is used.
Time setting, 12/24 hour mode and interval for the snooze
1. Press SET once (A7), the hours will fl ash. Using arrows
change).
2. Press SET again, the minutes' display starts fl ashing. Using arrows
3. Press SET, the display shows and fl ashes symbol "24H". Using arrows
format "12H" or "24H".
4. Press SET, the display shows and fl ashes the symbol "05". Using
alarm) in the range 5 to 60 minutes.
5. Press SET again (or after 10 seconds if no button is pressed), the device exits the setting mode.
Note: If you select the 12-hour clock format, the time will be displayed with symbol "P" (PM) in the afternoon
hours. There is no indicator for morning hours (AM).
Setting the alarm clocks
1. Press again AL 1.2 (A8) symbol 1 and hour fl ashes. Using arrows
of the fi rst alarm.
2. Press again AL 1.2 to set minutes. Using arrows
3. Press again AL 1.2. The display shows "OFF" (alarm off ). If you want to select the source of sound for the
alarm, select using arrows
rd: radio alarm
bu: buzzer alarm
OFF: alarm clock is off
4. Press again AL 1.2, the symbol 2 and the hour fl ashes. Using arrows
alarm clock.
5. Repeat the steps 2 and 3 to complete the setting of the second alarm clock.
6. If you press again AL 1.2 (or if you do not press any button in about 10 seconds), the device exits the alarm
clock setting mode. When you select the radio alarm or the buzzer alarm, that alarm will be activated,
which is indicated by display of symbol 1 and/or 2 on the left side of the display.
26
and
and :
a (A 2 and 6) set the hour (hold for speedy
and set minutes.
and
and set the snooze time (delaying
and (A 2 and 6) set the hour
set the minutes of the fi rst alarm clock.
and set the alarm of the second
select the time display