X120
Tip
Keep the adhesive cartridge cap somewhere safe if you do not intend to use
all the adhesive immediately. You can then replace the cap. Note the orienta
tion of the cap when replacing it: The section that was located on the side of
the cartridge holding the resin (black) must be replaced back on this side oth
erwise the adhesive in the cap will harden.
Attach the mixing nozzle: Insert and rotate clockwise by approx. 90°.
The applicator is then ready for use (Fig. 2.4).
Fig. 2.4:
Completed applicator with mixing nozzle attached
Tip
We recommend not using the first 10 cm of the X120 mixture; after that the
mixture will be optimal.
Apply the X120 adhesive where possible at room temperature.
A3326-1.0 en/de
9
HBM