10
2.2 Preliminary surface treatment
The surface must be dry and free of dust, oil, release agents and other con
taminants. When using cleaning media, comply with the applicable safety reg
ulations.
Important
You should never use a solvent that is technically pure; chemical purity is
essential.
2.3 Curing time
The graphic in Fig. 2.5 shows the required curing time, dependent on the
ambient temperature.
Fig. 2.5:
Curing time depending on ambient temperature
2.4 Cleaning
Residues of adhesive that has not cured can be removed with solvents (acet
one, methyl ethyl ketone). When using cleaning media, comply with the
applicable safety regulations.
HBM
X120
A3326-1.0 en/de