Bluetooth ® Pairing - Avinity ABT-632 Bedienungsanleitung

Note – Connection impaired
After the devices have been paired
once, the connection is then estab-
lished automatically. If the Bluetooth®
connection is not established automati-
cally, check the following:
• Check the Bluetooth® settings of your
terminal device to see whether Avinity
BTT-632 is connected.
• If not, repeat the steps listed in 5.2
Bluetooth® pairing.
• Check whether obstacles are impairing
the range. If so, move the devices
closer together.
• The performance can also be affected
by a weak battery.
5.5. Pairing in transmitter (TX) mode with
two devices at the same time
• Switch on the adapter and your two
Bluetooth -capable audio devices (BT
®
headphones/speaker) as described in 5.2
Bluetooth pairing.
®
• The adapter automatically names the two
terminal devices A and B, and establishes a
connection.
5.6. Deleting the pairing list
• Switch off the adapter in the current mode
(TX or RX). After approximately 3 seconds,
move the switch (1) to the other mode
and switch the adapter on again; this will
delete all paired devices from the list.
5.7. Battery capacity
• The status LED (3) begins flashing red when
the battery charge is low.
• Charge the adapter as described in 4.
Getting started.
6. Care and Maintenance
Only clean this product with a slightly damp,
lint-free cloth and do not use aggressive
cleaning agents.