Test Run - DUSCHOLUX Showerlux Step-in Sparkling + Music Montageanleitung

tESt run:

• Once installation work has been completed, i.e. before it is tiled in place, the Step-in
Sparkling + Music must undergo a test run
• Clean the bathtub thoroughly before filling for the first time
• Fill the bathtub with water (inlet temperature 40 +/- 5 °C) until whirlpool operation is assured
• Turn on the systems and let them run for 10 minutes under supervision. During this, check all
the functions described in the operating instructions
• After a further 10 min, switch the Step-in Sparkling + Music off and then check all of the
piping systems, the drain and overflow fittings for any leaks. Caution:
Do not drain the bathtub
• Check that all of the water runs out when emptying the bathtub
• If any rework (component adjustment, component replacement) be required, this process
must be repeated
• Grout the bathtub with silicone grouting in accordance with the instructions
notes about use:
• The Step-in Sparkling + Music must be cleaned and blown out after every use (also see
the operating instructions)
• We recommend the Duscholux bathtub cleaning agent (Art. no. 699.903200) and the
Duscholux whirlpool disinfectant (699.903310) for cleaning and care
• Do not use chlorine-based cleaning agents or solvents; this can cause damage to the pipework
• Do not use any abrasive cleaning agents
• Do not use any oil-based or foaming bath additives
16