Machine Start And Stop; Machine Operation (Scrubbing And Drying) - Viper AS510B Bedienungsanleitung

ENGLISH

MACHINE START AND STOP

Starting the machine
1. Complete the preparatory steps as related above.
2. Press the power switch (41) to the "I" position.
3. Use the squeegee handle (41) to lower the squeegee.
4. Press the Vacuum pump switch (42) to the "I" position.
5. Press the water flow volume control switch (44) to the "I" position. (Work simultaneously with the
safety switch (1) to control the work of solenoid valve.)
6. Hold the safety switch (1) and push to move the machine. The brush (29) starts to rotate, and the
machine starts its cleaning job.
CONSULTATION：The way to push the machine
One of the characteristics of the machine is the
Installation of two safety switches on both sides
of handlebar. Each safety switch is capable of
controlling independently the operation of the
brush. In use, it facilitates the control of the
operation of the machine.
By experience, the method to move the
machine shown on right Figure 11 is more
suitable, the users feel more comfortable on
hands, it reduces work fatigue. So the users are
recommended to move the machine in this way
Turning off the machine
7. When you have finished using the machine, first unload the brush/pad-holder (refer to the steps
related in the section on brush/pad-holder installation and
unloading)
8. Release the safety switch (1) to turn off the brush/pad-
holder and solenoid valve.
9. 9. Press the Vacuum pump switch (42) to the "O" position,
and the Vacuum pump will delay for 5 seconds before
stopping work.
10. 10. Press the water flow volume control switch (44) to the
"O" position to completely turn off the work of solenoid valve.
11. Press the power switch (41) to the "O" position.
12. Use the squeegee lifting handle (14) to lift the squeegee.
13. Grasp the handlebar (2) and gently tilt the machine
backward until the guide wheel (B) touches the floor. See
Figure 12.

MACHINE OPERATION (SCRUBBING AND DRYING)

1. Start the machine according to the description above.
2. Hold the safety switch (1) (according to the way shown in Figure 11), push to move the machine,
and start the cleaning job.
3. If necessary, turn off the machine, and adjust the regulating handle of the squeegee. (Refer to
the steps for adjusting the balance of the squeegee)
4. If necessary, turn off the machine, and adjust the volume of water flow with the ball valve handle.
(Refer to the steps of adjusting volume of water flow.)
CAUTION！
In order to avoid damaging the floor, when the machine stays in one place without
moving, please turn off the power switch (41).
Battery discharge during operation
5. It is only when the green warning light (38) is continuously lit that the power supply of the battery
is sufficient for the normal operation of the machine.
USER MANUAL
.
10
Figure 11
Figure 12