Electrolux LFG525S Gebrauchsanleitung Seite 5

painted appliances on the outside,
use a cloth dipped in lukewarm wa-
ter and neutral detergent. To clean
steel, copper or brass appliances
on the outside, it is always best to
use specifi c products, following the
instructions on the products them-
selves. To clean the inside of the
appliance, use a cloth (or brush)
dipped in denatured ethyl alcohol.
Clean grease fi lters in relation to use, at least
every 2 months to prevent the risk of fi re.
Hand wash or clean in a dishwasher using a
neutral detergent. If washing in the dishwa-
sher, possible discoloration of the fi lters does
not in any way compromise their functioning.
The activated charcoal fi lter is not washable
and cannot be regenerated, and must be
replaced approximately every 4 months of
operation, or more frequently for particularly
heavy usage.
4. CONTROLS
Models LFG525S, LFG525W, LFG525K:
Switch A: LIGHT; position 0: light off; position
1: light on.
Switch B: MOTOR SPEED: makes it possible
to select the motor operating speed; position
0: motor off.
C: Motor on light.
Models LFG517X, LFG615X, LFG615W:
Button P1: fi rst speed motor ON/OFF switch.
Button P2 (Models LFG615X, LFG615W):
Change motor speed (1-2-3-P-1-2-3-P....).
At fourth speed the letter on display "P" is on
(Booster). The 4th speed remain active for 5
minuts then going back in 3th.
Button P2 (Model LFG517X): Change motor
speed (1-2-3-4-1-2-3-4....).
Button P3: Timer. Activate and deactivate
timer (5 minuts). If the timer is active, the
number correspondent at the speed fl ashing.
Button P4: Lights. Turns the lights on/off.
Button P1 + P4 : Filter Alarm Reset. When
display shown an "F" letter fl ashing, the
grease fi lters must be cleaned (40 hours of
operation). When display shown an "C" letter
fl ashing, the charcoal fi lters must be repla-
ced (160 hours of operation) and the grease
fi lters must be cleaned.
Obviously, if the hood is not a fi ltering model
and does not have a charcoal fi lters, clean
the grease fi lters both when display shown
"F" and when display shown "C". The fi lter
alarm can be seen when the motor is off and
for about 30 seconds. To RESET the hour
counter, keep simultaneously the buttons
P1 and P4 pressed for 2 seconds while the
alarm can be seen.
5. LIGHTING
If the light spot is damaged, it must be re-
placed only by the manufacturer, its service
agent or similarly qualifi ed persons in order
to avoid a hazard.
ENGLISH 5