Peavey PV 10 Bedienungsanleitung Seite 29

Frequency Response
Mic Input to Left/Right Output
Total Harmonic Distortion
<0.02% 20 Hz to 20 kHz Mic to Left/Right Output (10 Hz to 80 kHz BW)
<0.005% Typical
<0.0007% Mic Pre-amp Distortion
Hum and Noise
Output Residual Noise
Master Left/Right -97 dBu
-90 dBu
-83 dBu
Monitor Send -95 dBu
-80 dBu
Effects Sends -100 dBu
-80 dBu
(Hum and noise measurements: 22 Hz to 22 kHz BW)
Equivalent Input Noise (EIN)
-129 dBu (input terminated with 150 Ohms)
Crosstalk/Attenuation
Adjacent Input Channels (1 kHz) >90 dB
Left to Right Outputs (1 kHz)
Common Mode Rejection Ratio (Mic Input)
50 dB minimum (20 Hz to 20 kHz)
70 dB typical @ 1 kHz
Meters
8 segment, peak reading (0 dB = +4 dBu)
Signal/Overload Indicators
Red LED lights 3 dB below clipping
Dimensions
PV 10: 12.125" wide x 14.75" deep x 3.5" high (30.80cm x 37.47cm x 8.89cm)
PV 14: 16.125" wide x 14.75" deep x 3.5" high (40.96cm x 37.47cm x 8.89cm)
Installation Note:
This unit must have the following clearances from any combustible surface: top: 8", sides: 12", back: 12"
Weight
PV 10: 9.3 lbs. (4.22 kg)
PV 14: 12.1 lbs. (5.49kg)
Power Requirements
PV 10: 100-240 VAC 50/60 Hz 13 Watts
PV 14: 100-240 VAC 50/60 Hz 17 Watts
14 Hz to 25 kHz +0 dB/-1 dB
(22 Hz to 22 kHz BW)
S/N Ratio (Ref: +4 dBu)
101 dB
94 dB
87 dB
99 dB
84 dB
104 dB
84 dB
Mute Button Attenuation (1 kHz) >90 dB
>75 dB Channel Fader Kill (1 kHz)
Test Conditions
Master Fader Down‚ Channel Levels Down
Master Fader Nominal‚ Channel Levels Down
Master Fader Nominal, Channel Faders Nominal,
Panned Odd Channels (left), Even Channels (right)
All controls off
All channel sends nominal, masters nominal
All controls off
All channel sends nominal, masters nominal
>85 dB
15