Slave Mode - Cameo STUDIO PAR 64 CAN Bedienungsanleitung

MODE SELECTION:
AUTO MODE
Press the MODE button repeatedly if necessary to select the Auto Mode.
The unit changes between Colour Jumping Mode and Colour Fading Mode
automatically. The colour jumping and fading speed can be preadjusted by
using the speed settings of the Colour Jumping and Colour Fading Modes.

SLAVE MODE

Press the MODE button repeatedly if necessary to enter the Slave Mode.
Link slave units and the master unit (exclusively standalone modes) via
DMX cables. The slave unit will follow in sequence with the master unit.
SOUND CONTROL MODE
Press the MODE button repeatedly if necessary to select the Sound Control
Mode (SUXX). The unit will follow the beat of the music thanks to the built
in microphone. Press ENTER again (3. and 4. digit blink) to adjust the sensi-
tivity of the microphone (SU00 - SU99) by using the UP and DOWN buttons.
Press ENTER to confirm.
DMx MODE SELECTION
Press the MODE button to enter DMX MODE SELECTION (repeatedly if ne-
cessary). Press ENTER (1st digit blinks) and select the desired DMX mode
by using the UP and DOWN buttons. Press ENTER again to confirm.
Note: See the description of the different DMX modes on the following
pages of this manual.
DMx ADDRESS SETTING MODE
Press the MODE button repeatedly if necessary to enter the DMX Address
Setting Mode (AXXX).
Press ENTER to access edit mode (the last 3 digits blink) and select the
desired DMX start address by using the UP and DOWN buttons (A001 -
A512). Press ENTER to confirm.
NOTE:
The LED display automatically turns off after about 1 minute and turns on
again by pressing any of the 4 buttons.
11