Philips Lumea Bedienungsanleitung Seite 22

22
English
90º
4 Place the device at a 90° angle on the skin so
that the integrated safety system is in contact
with your skin.
The integrated safety system prevents
unintentional flashing without skin contact.
5 Press the device firmly onto your skin to ensure
proper skin contact. The 'ready to flash' light
lights up green to indicate that you can proceed
with the treatment.
Note: When the 'ready to flash' light starts
blinking orange, your skin is not suitable for
treatment. In this case, the device automatically
disables. You can try to use the device on other
areas with a lighter skin tone.
Note: If the ' ready to flash' light does not light
up green, the device is not completely in
contact with your skin.
TIP: If you use Lumea on your bikini area and
want to leave some hair in place, make sure
that the skin tone sensor is not placed on the
remaining hair during the treatment, as this can
cause the device to block
6 Press the flash button to release a flash. The
devices makes a soft popping sound. You
should feel a warm sensation because of the
flash.
Note: The scattered light produced by the
device is harmless to your eyes. It is not
necessary to wear goggles during use. Use the
device in a well-lit room so that the light is less
glaring to your eyes.